Ensun Crankcase Vent Valve Oil Separator with Breather Hose Kit Set Compatible with N52 E90 E91 E60 E61 E85 E86

The hose’s worked but the bottom one going too the pan did not have a one way check valve in it so had too get another one from someone else witch was a big pain so make shur too check for that before installing good luck

So I bought a 06 330I with all kinds of issues and I had no prior BMW experience. Fighting CEL codes and idle issues I've replaced a lot of parts. I did a smoke test and found the CCV system had broken lines. The kit that would fit my car perfectly was like $400 so I ordered this kit knowing that I would not be using the "Y" hose. Luckily the one on my car was the only hose not broken. My car was built in August of 05. Everything in this kit fit perfect except the hose that goes into the oil pan had 2 O-rings on it and I tried everything to get the hose on. Removed one O-ring still no luck. Removed both and it popped right on. No CEL lights so I assume there's no vacuum leak there. What did happen was since the CCV was bad for so long it has been dumping oil into the convetors and then the car threw the codes for the rear O2 sensors saying cats are bad. I added the O2 extensions and that fixed my issue. I did destroy the 1-3 cyl O2 trying to get it out. FYI spray with penetrating oil for a few days then use a small adjustable wrench and a 5lb hammer! None of the fancy O2 tools would work. Or tune out the sensors. But yes great CCV KIT!

The media could not be loaded.  I broke both PCV hoses taking the intake manifold apart on my 2006 E90 325i N52B25 euro spec, to retrieve a broken disa flap out of number 3 intake port. After reasemble the car was running like garbage (it ran like the engine was blown) and disconnecting the MAF sensor helped, but it was still pretty rough. After swapping the whole PCV system, car now runs great and the engine has vacuum again. The only downside of this kit, is that the gasket on the lower PCV hose for the crankcase side will not work even after oiling it (too thick) so I had to remove the gasket and install a new one. Every other connection point (Lower hose to pcv valve, pcv valve to upper hose and upper hose to cam cover) works perfectly and seals great. Recommended if you are down to swap the gasket on the lower PCV hose and have enough patience to go through the installation of the kit (which is a nightmare if you cannot lift the car in the air)

I decided to purchase this kit for my 2006 BMW 330i after discovering that my local auto parts store will only sell you individual hoses. Once, this kit arrived, I compared it to the OEM oil separator on my intake manifold and I was 100% impressed with the quality of the hoses/sensors and the exact fitment. This kit is OEM quality at a unbeatable price. Definitely Recommend.

This is a quality replacement for 2006 325i E90 (3.0L). I read somewhere that the Y shaped tube doesn't fit, not sure why someone assumed this. The hose/pipe is a bit flexible, I mean it wasn't lining up perfectly, just a 3/4 in away from where it plugs, bend it gently and it should click in with no issues. Will be installing it soon